Image 1 of 5
A shelf on your radiator, without drilling a single hole
From €24.90 to €83.90
Choose: Pack, Colour
When you rent, drilling a wall comes out of your deposit. The top of the radiator is often the only free surface in the room, and it is useless: too narrow to put anything on, too uneven to hold a board.
The bracket sits on the top edge of the radiator and spreads the load down the full height of the fins. Lay a board on top and it stays put. Nothing to screw, nothing to glue, and it all comes off in ten seconds on moving day, without leaving a mark.
You rest the bracket on the top edge of the radiator. That is the whole installation. No tools, no instructions, no holes. Gravity does the rest.
A radiator gets hot, and a PLA printed part softens then creeps under load. ASA is what car mirrors and grilles are made of: it takes sun, rain and heat. Past 100 degrees, it does not move.
A shelf always needs two brackets. The menu lets you pick enough for one to four shelves. The board is not included: buy it cut to size, raw or painted, the look is your call.
The standard model takes a 20 mm board. If yours is 15, 18, 22 or 25 mm, say so in the order note: I cut the model to your measurement, at no extra cost and with no added delay.
Every bracket is printed to order, one at a time, in my workshop. Allow three working days before dispatch.
Light loads only. Everyday items: books, a small plant, a speaker, a cup, keys, a phone. Three kilos maximum per shelf, spread across the board. Never place anything on it that would hurt someone or break if it fell. Do not use as a step or a handhold. Contains small parts, keep away from children under three.
No reviews yet.
Only customers who have received this piece can leave one. The first review will therefore come from a buyer, once the first orders have shipped.