Skip to content

You decide what follows you

This site sets trackers, described in detail under “Choose”. They only load with your consent, and your refusal is kept for as long as your consent would be.

Privacy policy
A pair of sneakers upside down on two black shoe dryers sitting on a white radiator
A pair of sneakers upside down on two black shoe dryers sitting on a white radiator
Two black shoe dryers on top of a radiator
Two black shoe dryers on top of a radiator
Fitting the shoe dryer on the radiator, then a pair of sneakers slid onto it
Key points: no drilling, dries from the inside, PETG, one holder per shoe
Key points: no drilling, dries from the inside, PETG, one holder per shoe
Fits panel radiators, not cast iron column radiators
Fits panel radiators, not cast iron column radiators

Image 1 of 5

Radiator shoe dryer

Your shoes dry upside down, right above the radiator

€23.72

Quantity: 2 holders (1 pair)
Colour To choose
You are ordering: 1 x 2 holders (1 pair)

A measurement, a board thickness: the piece is made to your size.

0 / 300 characters

Choose: Colour

In short

  • Sits on the radiator, nothing to screw or glue
  • The shoe goes on upside down, so warm air rises straight into it
  • Sold individually, one holder per shoe, from 1 to 10

The problem

Laid flat on a radiator, wet shoes dry badly: the sole blocks the heat, the inside is still damp the next morning, and they end up falling down the back.

The solution

The holder sits on the top edge of the radiator, just like our brackets. Its angled peg holds the shoe upside down, opening facing down, right above the fins. The warm air rising from the radiator goes straight into the shoe and dries it from the inside.

Description

Fitting it

You rest the holder on the top edge of the radiator, with the back leg slipped between the radiator and the wall. No tools, no holes. Slide the shoe upside down onto the peg, sole facing up. It comes off in a second when winter is over.

Your radiator

You need at least 64 mm of space between the back of the radiator and the wall, the same as for our standard bracket. Measure at the narrowest point before ordering. The holder fits panel radiators with a flat or grilled top.

Sold individually

One holder takes one shoe. Pick two for a pair, four for two pairs, and so on up to ten. The price per piece goes down with the quantity.

Why PETG

PETG stays rigid at the temperature of a central heating radiator and does not mind the moisture of a wet shoe.

Made to order

Every holder is printed to order in my workshop in Lyon, in black or white. Allow three working days before dispatch.

Technical details

Material
PETG
Dimensions
161 mm deep, 192 mm tall, 20 mm thick
Radiator to wall gap
64 mm minimum
Peg
100 mm, angled towards the room
Sold as
Single piece, one holder per shoe
Made
Printed to order in France

Safety warning

One shoe per holder. Not suitable for boots or heavy safety shoes. Do not place on an appliance whose surface goes above 80 degrees, or on an electric heater with an exposed element. Do not use as a handhold. Keep out of reach of young children.

Manufacturer and traceability

Manufacturer
Nyllao3D
Product identifier
NYL-SEC
Country of manufacture
France

Customer reviews

No reviews yet.

Only customers who have received this piece can leave one. The first review will therefore come from a buyer, once the first orders have shipped.

You may also like